![]() |
---- IMPORTANT NOTE ----
If riding your ATV in altitudes of 6000 ft. or above, please make a note on your order in the Special Instructions section of the order form, as these particular units must be vented to allow airflow. ATV Exhaust Systems
If you do not see your particular model listed under ATV Exhaust Systems -, please call us at 866-501-3825 toll free and we can always check to see if we have anything for your ATV. The ATV Exhaust Systems - attaches to the stock -. If there is not enough lip or tail pipe to attach to, then an adapter is required to complete the installation. Some adapters need to be welded to the stock pipe to create an attachment point. Other models have an optional bolt on adapter that is available for an extra $21.95. Also, there are some models that do not require any type of adapter. Some particular ATV Exhaust Systems Adapters - need to be welded to the tail pipe that drops out the bottom of stock -. This gives the silencer something to attach to. The silencer is not permanent, just the 1 1/2" adapter. Note: The ATV Exhaust Systems - is not a permanent device, you can choose to leave it on or take it off by 2 bolt hangers. The ATV Exhaust Systems - is easy to install. Depending on whether or not an adapter is needed, here are is the general procedure. The ATV Exhaust Systems is slid over the attached adapter, if needed. Drill 2 small holes in the cross member. Then place the silencer onto the adapter and insert bolts through flat hanger brackets and through cross member. Follow with rubber grommets, washer, and nut. Tighten for secure hold.
The ATV Exhaust Systems fits most any ATV with a four stroke engine to quiet the stock noise by 60-80%, without sacrificing any engine performance. Some ATV Exhaust Systems systems require welding to the stock exhaust in order for the muffler to be attached. Our ATV Exhaust systems have easy installation and are not permanent; they can be removed as desired. The adapter for the ATV Exhaust Systems , if needed, will be the only permanent attachment made to the stock muffler. The Benz Silent Rider ATV Exhaust Systems is ideal for hunters who want to be quiet in the woods. The silent ATV Exhaust Systems system supports many models made by the following manufacturers: Yamaha, Kawasaki, Honda, Polaris, Artic Cat, & Suzuki If you do not see your particular model listed under ATV Exhaust, please call us and we can always check to see if we have anything for your ATV. The ATV Exhaust Systems attaches to the stock muffler. If there is not enough lip or tail pipe to attach to, then an adapter is required to complete the installation. Some adapters need to be welded to the stock pipe to create an attachment point. Other models have an optional bolt on adapter that is available for an extra $21.95. Also, there are some models that do not require any type of adapter. Some particular ATV Exhaust Systems Adapters need to be welded to the tail pipe that drops out the bottom of stock muffler. This gives the silencer something to attach to. The silencer is not permanent, just the 1 1/2" adapter. Note: The ATV Exhaust Systems is not a permanent device, you can choose to leave it on or take it off by 2 bolt hangers. The ATV Exhaust Systems is easy to install. Depending on whether or not an adapter is needed, here are is the general procedure. The
ATV Exhaust Systems is slid over the attached adapter, if needed. Drill 2 small holes in the cross member. Then place the silencer onto the adapter and insert bolts through flat hanger brackets and through cross member. Follow with rubber grommets, washer, and nut. Tighten for secure hold.
|