ATV/UTV Silencers-Silent Rider(Benz)

     
 
Video Goes Here
 
     

Highlights: - ATV Exhaust

  • Affordable
  • High Quality, with no parts to assemble or replace.
  • Designed with heat shield.
  • Attaches to factory muffler in minutes.
  • Quietest system for 4-stroke ATV's up to 60% noise reduction!
  • U.S. Forestry approved spark arresters.
  • Mounting brackets are sturdy, no rattling.
  • Used by Police, Wildlife, National Parks, and other SATISFIED Hunters!
  • Starting at $172.00!!
  • Does Not Support Any 2 Stroke Engines
 

ATV/UTV Silencers-Silent Rider(Benz)

Benz ATV Silent Rider

 

About our ATV/UTV Silent Rider Silencers

Our ATVUTV Silent Rider Silencers fit most any ATV/UTV with a four stroke engine to quiet the stock noise by up to 60%. Some ATV/UTV Silencers require welding an adapter to the stock exhaust in order to be attached. Our ATV/UTV Silent Riders Silencers have easy installation and are not permanent. They can be removed as desired. The adapter for the Benz ATV Silent Rider, if needed, will be the only permanent attachment made to the stock exhaust. The ATV/UTV Silent Rider Silencer is ideal for hunters who want to be quiet in the woods. Our silencers support many models made by the following manufacturers: Yamaha, Kawasaki, Honda, Polaris, John Deere, Bob Cat, Can-Am, Artic Cat, Powersports & Suzuki.

If you do not see your particular model listed, please call us at 877-327-5270 toll free and we can always check to see if we have anything for your ATV/UTV. The ATV/UTV Silent Rider Silencer attaches to the stock exhaust. If there is not enough lip or tail pipe to attach to, then an adapter is required to complete the installation. Some adapters need to be welded to the stock pipe to create an attachment point and are supplied with the unit. Other models have an optional bolt on adapter that is available for an extra $27.95. Also, there are some models that do not require any type of adapter. Some particular adapters need to be welded to the tail pipe or muffler of the stock exhaust. This gives the silencer something to attach to. The silencer is not permanent, just the 1 1/2" adapter. Note: The ATV/UTV Silent Rider Silencer is not a permanent device, You can choose to leave it on or take it off by 2 bolt hangers. The silencer is easy to install. Depending on whether or not an adapter is needed, the following is the general procedure. The silencer is slid over the attached adapter, if needed. Drill 2 small holes in the cross member. Then place the silencer onto the adapter and insert bolts through flat hanger brackets and through cross member. Follow with rubber grommets, washer, and nut. Tighten for secure hold. 

There are no products matching the selection.